Whole House Repipe in San Diego

Open wall showing new water lines during a whole house repipe in San Diego

A repipe replaces the hot and cold water lines in a house with new pipe, from the main shutoff to the valve under every sink and toilet. It’s the right job when the pipes themselves are worn out and each repair only buys time until the next leak. Courtesy Plumbing does whole house repiping in San Diego on weekdays, 8 AM to 5 PM. A repipe is a big project, but it’s a predictable one when it’s planned well. Here’s what it covers, how the days go, and what your quote should spell out.

What a Repipe Replaces, and What It Doesn’t

  • Replaced: every hot and cold water line inside the house, the connections to the water heater, and the supply to each fixture and appliance.
  • Usually added: new shutoff valves under sinks and toilets, new supply lines, and a new main shutoff if the old one is a stiff gate valve.
  • Not included unless stated: drain and sewer pipes, the water line from the meter to the house, and the fixtures themselves.

Drains are a separate system with their own lifespan. If yours are old cast iron, ask us to look at them during the same visit, since the walls will already be open.

Signs the Pipes Are Finished

  • More than one leak in a year, especially pinhole leaks in copper.
  • Galvanized steel pipe. It rusts from the inside, and the first clue is weak flow that keeps getting worse.
  • Rusty or discolored water when a faucet is first opened.
  • A second leak under the slab. Our slab leak repair page explains when a single reroute is enough and when it isn’t.

Weak flow alone doesn’t prove the pipes are done. A failing pressure regulator or a clogged fixture can look the same, so we test before recommending a repipe. Our low water pressure diagnosis page lists the simpler causes.

PEX or Copper

California’s plumbing code approves both for water lines inside a house, and both have to be certified for drinking water. The choice comes down to the house and your priorities.

 

PEX

Copper

What it is

Flexible plastic tubing, run in long lengths.

Rigid metal pipe, joined with fittings.

Wall openings

Fewer. It bends around corners, and code allows changes of direction without a fitting.

More. Each turn is a fitting or a careful bend.

Joints

Few hidden joints, mostly at each end of a run.

A joint at every fitting.

Where it can’t go

Not in direct sunlight, so exposed outdoor runs are done in copper.

No such limit.

Cost and time

Usually less of both.

Usually more of both.

There’s no single right answer. We helped one homeowner choose the approach that suited their particular house before any work began, and that conversation is part of every repipe quote. Many jobs end up as a mix: PEX through the attic and walls, copper at the water heater and anywhere pipe is exposed.

How the Work Runs

  1. Walkthrough and count. We count every fixture, find the route for the new lines and mark where openings are needed.
  2. Permit. Replacing a home’s water piping is permit work in the City of San Diego. We pull it.
  3. Protect the house. Floors and furniture are covered before any cutting.
  4. Run the new lines. New pipe goes through the attic, crawlspace or walls, with small openings behind fixtures. Lines under a slab are abandoned in place, so no concrete is broken.
  5. Insulate the hot lines. Code requires hot water piping to be insulated, and it keeps the water in the line warm longer between uses.
  6. Test. The new system is pressure tested and has to hold with no leaks for at least 15 minutes, as code requires. The inspector sees the pipe before walls are closed.
  7. Switch over. Fixtures are moved to the new lines, the system is flushed and every faucet and toilet is checked.

Living in the House During a Repipe

You don’t have to move out. The old pipes stay in service while the new ones are being run, so the water is off only during the changeover, not for the whole project. On one whole-house job, sections of the home had running water through most of the work.

Good sequencing is what keeps the shutoff short. On one house, our crew lined up 16 separate tasks and finished them in a single day for exactly that reason. Timelines vary with the size of the house and how hard the pipes are to reach. A small single-story house goes quickly. An older two-story house with brittle pipe in tight walls takes longer, and we give you the day count before we start.

Worth Doing While the Walls Are Open

  • Shutoff valves. We replaced the valve under every sink and toilet in one 24-year-old house purely as prevention. During a repipe it adds little.
  • Pressure regulator. New pipe deserves correct pressure. See pressure regulator installation.
  • Recirculation line or filter loop. Both are far easier to add now than later.
  • Outdoor faucets. Old hose bibs can be replaced or moved at the same time.

What a Complete Repipe Quote Lists

  • The pipe material, and where each type will be used.
  • The number of fixtures and appliances being connected.
  • Whether new stop valves and supply lines are included.
  • The permit and inspection.
  • Who patches the wall openings, and to what finish.
  • How many days, and how long the water will be off.

If two quotes are far apart, the difference is usually in this list. The California Plumbing Code sets the minimum for materials, support and testing, and a quote should meet all of it.

To talk through a repipe, call (858) 567-0544 on a weekday from 8 AM to 5 PM. You can also send the age of the house and what you know about its pipes through the Contact Us form. Tony Misleh, a master plumber, founded Courtesy Plumbing in 2007. Our state contractor license is CSLB #910268.

Contact Us

    For Same-Day
    Water Heater Service,
    Call Us On

    (858) 567-0544

    Check Out Our Ratings!