Sewer Line Installation in San Diego

Trench dug along a San Diego home for a new sewer line installation

A sewer line is the one pipe every drain in the house depends on. When it has cracked in several places, sagged, or filled with roots along its length, patching one spot only moves the next failure a few feet down the pipe. Courtesy Plumbing handles sewer line installation in San Diego for houses that need a new or replacement line from the building out toward the street. Our hours are 8 AM to 5 PM, Monday to Friday. This page explains when a full replacement makes sense, what a correctly installed line includes, and how the permits work.

One note first. If the line is simply blocked, it needs clearing before anyone can judge the pipe. Clearing is done by Drain Mob, our partner company for drain work. Once the line is open, the condition of the pipe itself decides the next step, and that part is ours.

Repair One Section, or Install a New Line?

A camera inspection settles most of this question, because it shows the whole run instead of the one spot that backed up. Our post on what to expect during a sewer camera inspection explains what the footage shows. In general:

  • One break in otherwise sound pipe is a section repair. Our sewer line repair page covers that job.
  • Damage in several places points to replacement. So do roots at joint after joint, or a low spot that holds water. A low spot, often called a belly, can’t be patched from inside, because the pipe itself has to be set back on grade.
  • Old clay, concrete or cast iron along the whole run is a line near the end of its life. The City of San Diego notes that these older materials are the ones prone to roots and deterioration, while plastic pipe with sound joints holds up for years.

We see the pattern often. On one job, a ceiling leak in a downstairs bedroom had been blamed on a toilet flange by another company. Our plumber found the flange dry and traced the water to 30-year-old waste pipes leaking in several places. Patching one of them would have fixed nothing, so the drain system was replaced, and the work was finished within a week.

Which Part of the Line Is Yours

In the City of San Diego, the pipe that carries waste from your house to the public main is known as the lateral, and the owner is responsible for all of it. That includes the part that runs beneath the sidewalk and the street. City crews don’t dig on private property. So when a lateral fails, the replacement is the homeowner’s project. The first thing to pin down is how far the damage runs: to the property line, or all the way to the main.

What a Correctly Installed Sewer Line Includes

Most of what makes a new sewer line last is invisible once the trench is filled. These are the points the California Plumbing Code and the City set, and the ones an inspector checks:

Item

What is required

Why it matters

Pipe size

The City sets 4 inches as the minimum for a sewer lateral, and a building sewer can never be smaller than the drain it serves.

An undersized line clogs under normal household use.

Slope

A steady fall of at least 1/4 inch per foot toward the street. A flatter 1/8 inch per foot is allowed on 4-inch and larger pipe only with approval.

Too flat and solids settle. Uneven slope creates bellies.

Bedding

The pipe has to rest on a firm bed along its entire length.

Pipe laid on loose fill settles later and loses its slope.

Cleanouts

One near where the house drain meets the sewer, brought up to ground level. More are required every 100 feet and where bends add up to more than 135 degrees.

A cleanout lets the line be cleared and inspected without pulling a toilet.

Depth and distance

Pipe of a material not approved for use inside a building has to stay 2 feet clear of the structure and at least 1 foot below the surface.

Protects the pipe from loads and the building from leaks.

Water test

The new sewer is plugged at the street end and filled with water from its lowest to its highest point. It has to be watertight.

Leaks are found before the trench is closed.

Two more rules come up on some lots. If the new sewer shares a trench with the water line, the code sets how the two are separated. If any fixture sits lower than the next upstream manhole cover in the street, those fixtures need a backwater valve so sewage from the main can’t flow back into the house.

Permits: On Your Property and in the Street

Replacing a sewer line is permit work, and there are two different cases.

From the house to the property line. The work goes under a City plumbing permit, and an inspector sees the pipe, the slope and the water test before the trench is filled. We pull that permit and schedule the inspection as part of the job.

From the property line to the main. Work in the public right-of-way needs a separate Right-of-Way Permit with a construction plan showing the main, the lateral and nearby utilities. The City allows a licensed contractor to make the connection to the sewer main, normally with a wye fitting. An old lateral that will no longer be used has to be capped at the property line. The City’s Information Bulletin 166 lists the full requirements. Street work adds plan review, traffic control and paving repair, so we tell you which case your house falls into before you get a quote.

How the Job Runs

  1. Locate. The line is traced and its depth measured, and 811 is called so buried gas, electric and water lines are marked before any digging.
  2. Open the route. That may be a trench across the yard, or cuts through a driveway or patio where the pipe runs under them.
  3. Set the pipe. New plastic sewer pipe goes in on a firm bed at a measured slope, with cleanouts brought up to the surface.
  4. Test and inspect. The line is filled with water and the inspector signs off while the pipe is still visible.
  5. Backfill. The trench is filled and compacted in layers, so the ground doesn’t settle later and take the pipe with it.

How long this takes depends on depth, length and what sits on top of the pipe. A shallow run across open lawn is a short job. A deep line under concrete is not. We once fixed a sewer leak that sat inside a home’s footing, which is slow, careful work and nothing like a trench across a yard. Tree roots, slabs and other buried utilities all change the plan, and our post on an electric wire over a sewer line shows one example.

If Digging Isn’t the Right Answer

Some lines can be rebuilt from the inside with an epoxy liner, with no trench at all. Lining needs a pipe that still holds its shape and its slope, so it won’t correct a belly or a collapsed section. It’s specialized drain and sewer work that we refer to Drain Mob. Our epoxy pipe lining page explains what it fixes and what it doesn’t, so you can compare both routes.

What to Ask Before You Accept Any Bid

  • Does the price cover the line to the property line, or all the way to the main?
  • Which permits are included, and who schedules the inspections?
  • How many cleanouts will be added, and where?
  • Is concrete, paving or landscape repair included, or priced separately?
  • Will the new line be water tested before it’s covered?

For a new or replacement sewer line, reach us at (858) 567-0544 on a weekday between 8 and 5. If you already have camera footage or a written report, attach or describe it in a message through Contact Us and we’ll start from there. Tony Misleh, a master plumber, has owned and run Courtesy Plumbing since he opened it in 2007. Our California license number is CSLB #910268.

Contact Us

    For Same-Day
    Water Heater Service,
    Call Us On

    (858) 567-0544

    Check Out Our Ratings!